Advanced Vehicle Functions V1.7.0.0 FS25
Advanced Vehicle Functions V1.7.0.0 FS25
Advanced Vehicle Functions
Note: Four-wheel drive and differentials must be purchased separately in the shop for each desired vehicle.
Important: The key bindings must be configured; nothing has been preset.
Analog joystick control for throttle and brake
Switchable analog drive lever
Glow plug system for cold engines
Display of engine speed and engine temperature in the HUD
Functional handbrake
Sounds when applying and releasing the handbrake
Sounds from the four-wheel drive and differentials
Selectable four-wheel drive
Separate differential locks for the front and rear axles
Four-wheel drive and differential can be purchased in the shop.
Realistic compressed-air braking system for vehicles
Simulated air pressure from 0 to 10 bar
Speed-dependent compressor output
Air consumption when braking and using the handbrake
Air consumption when connecting a compressed-air trailer
The handbrake cannot be released if the air pressure is too low.
Reduced braking performance at low tire pressure
Load-dependent vehicle center of gravity
Dynamic load shifting in curves and on slopes
Increased risk of tipping due to loaded trailers and raised implements
Increased pushing force from heavy trailers on downhill sections
Load loss with covers open and at higher driving speeds (minor)
Detection of rollovers and vehicle accidents
Spillage or loss of bulk material after an accident (must be loaded with a front loader)
Towing service for damaged vehicles
Towing costs are calculated based on the distance to the repair shop.
Joint lifting and lowering of front-mounted implements
Joint lifting and lowering of rear-mounted implements
Simultaneous lifting and lowering of all attached implements
Separate activation and deactivation of front and rear implements
Simultaneous activation and deactivation of all implements
Separate folding and unfolding of front and rear implements
Simultaneous folding and unfolding of all implements
The camera automatically rotates in the interior view when reverse gear is engaged. This can be disabled in the general settings.
The helper automatically applies the handbrake in helper mode.
Automatic drivetrain (intelligent automatic control of four-wheel drive and differential). The four-wheel drive has 2 systems and can be engaged at any time.
The slight vibration of the interior camera is intended to simulate the running engine.
The front loader can be raised and lowered faster at idle by increasing the throttle (engine speed).
When starting the engine, the key or button (ignition switch) must be held down for 0.8 seconds; otherwise, the vehicle will not start (this is intended to simulate a real ignition switch).
Marcus (Cobra Modding)
