Swather Tedder Plus V1.1.3.0 FS25
Swather Tedder Plus V1.1.3.0 FS25
Automatic detection of the number of rotors and arms with corresponding adjustment of spare parts consumption. If detection is not possible, default values are used.
Wear, overload damage and purchasable spare parts for windrowers and tedders in LS25.
Swather / Tedder Plus
When windrowing and tedding, tines, tine guards or catcher bars, as well as claw couplings, wear out. High workloads cause additional damage. For supported equipment, the required parts are adjusted based on the rotors and support arms. Without correct identification, default values corresponding to the working width apply.
Menu and Easy Mode
Open General Settings in the pause menu → Swather / Turner Plus and select the operating mode.
The mod functions are paused when they are switched off. The equipment then operates with the normal LS25 functions.
Easy disables blockages for players and helpers and clears existing blockages. Load, load limit, wear and spare parts maintenance remain active.
This activates all mod functions. If a blockage occurs, the field helper ends their task and reports the reason. Restart them after clearing the blockage.
The operating mode is saved in the savegame. In multiplayer, it is set by the host or server administrator.
Spare Parts and Partial Maintenance
You can find suitable spare parts under HMT Ersatzteile. Individual crates contain 50 tines, 100 tine holders or ten claw couplings. You can buy several crates at the same time. Pallets are available for larger quantities.
Stop the equipment and switch it off. Raise passive rakes or tedders for maintenance. By default, place crates or pallets from your farm within five metres. Partial maintenance starts as soon as a suitable spare part is available. If ten parts are required and five are available, five are installed. The final message shows the remaining number of parts required.
Emptying the pallet takes eight seconds and does not consume spare parts. Replacing the parts takes 20 seconds. The parts are consumed after successful completion. Partially used boxes and pallets retain their remaining contents.
HUD and Controls
The HUD displays the workload and component status. You can adjust the font size (large or small) for your personal HUD.
Left Ctrl + left Alt + 3 toggles the HUD on or off.
Left Ctrl + left Alt + 4 toggles move mode on or off. Drag the HUD while holding the left mouse button. Camera and zoom inputs are locked during this time.
Left Ctrl + left Alt + 5 switches the HUD size between 50, 25, 20 and 75% of the speedometer width.
Ctrl + Alt + Caps Lock starts or ends maintenance, unless a custom maintenance key has been saved.
Under Options → Controls, the HUD actions and maintenance functions can be freely assigned. A saved keyboard or controller binding for maintenance replaces the default Caps Lock key.
hank_madness_
